Work Procedure

WARNING: This page is about a different car, the 2020 Infiniti QX80. However, it is still accessible from the selected car via links, so may be relevant.

Since vehicle specifications are not included in the lane camera unit after replacement, it is required to write vehicle specifications with CONSULT.

Configuration has three functions as follows.

Function		Description
Read/Write Configuration	Before Replace ECU	Allows the reading of vehicle specification written in lane camera unit to store the specification in CONSULT.
	After Replace ECU	Allows the writing of the vehicle information stored in CONSULT into the lane camera unit.
Manual Configuration		Allows the writing of the vehicle specification into the lane camera unit by hand.

SAVING VEHICLE SPECIFICATION
WITH CONSULT

Perform "READ CONFIGURATION" to save or print current vehicle specification.

Is vehicle specification saved normally?

YES

GO TO 2.

NO

GO TO 4.
REPLACE LANE CAMERA UNIT
Replace lane camera unit. Refer to LANE CAMERA UNIT : Removal & Installation .

GO TO 3.
WRITING VEHICLE SPECIFICATION
WITH CONSULT

Perform "WRITE CONFIGURATION - Config file" to write vehicle specification.

GO TO 6.
REPLACE LANE CAMERA UNIT
Replace lane camera unit. Refer to LANE CAMERA UNIT : Removal & Installation .

GO TO 5.
WRITING VEHICLE SPECIFICATION
WITH CONSULT
1. Select "WRITE CONFIGURATION - Manual selection"
2. Touch "Next".
3. Touch "OK".
4. Check that the configuration has been successfully written and touch "End".
GO TO 6.
OPERATION CHECK
Confirm that following functions operate normally.
- LDW/LDP: Refer to Work Procedure .
WORK END