Programmable Driver Door & Liftgate Unlock Feature

The system can be programmed to unlock all the doors and liftgate upon the first Unlock button press by using the following procedure:

1. Enter vehicle and close all doors.
2. Fasten seat belt to cancel unwanted chiming.
3. Place key in ignition switch.
NOTE: DO NOT start engine in this step.
4. Within 10 seconds, cycle the ignition switch from OFF position to ON position 4 times, ending in the ON position.
5. Within 30 seconds, press the driver door lock switch in the Unlock direction.
6. A single chime will be heard to indicate the feature has been disabled.
7. To reactivate this feature, repeat steps above.
8. If a chime is not heard, program mode was cancelled before the feature could be disabled. If necessary, repeat procedure.