LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2003 >> SSR Base >> Repair and Diagnosis >> Brakes >> Antilock Brake System With Traction Control System >> Diagnostic Information and Procedures >> Traction Off Indicator Always On >> Test Description
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Test Description

The number below refers to the step number on the diagnostic table.

  1. 3:  This step tests if the IPC is able to turn OFF the traction off indicator.
Traction Off Indicator Always On

Step Action Yes No
Schematic Reference:  ABS Schematics  
Connector End View Reference:  ABS Connector End Views  
1 Did you perform the ABS Diagnostic System Check? Go to Step 2  Go to Diagnostic System Check - ABS 
2
  1. Turn OFF the ignition for 5 seconds.
  2. Turn ON the ignition while observing the traction off indicator.
Does the traction off indicator illuminate for approximately 2 seconds and then turn OFF?		 Go to Diagnostic Aids Go to Step 3 
3 
  1. Select the Instrument Panel Cluster Special Functions menu on the scan tool.
  2. Select Lamp Tests.
  3. Command the instrument panel cluster (IPC) indicator lamps Off.
Does the traction off indicator turn OFF?		 Go to Step 5  Go to Step 4 
4 Replace the instrument panel cluster. Refer to Instrument Panel Cluster (IPC) Replacement in Instrument Panel, Gages, and Console.
Did you complete the replacement?		 Go to Step 6  -
5
IMPORTANT: Following electronic brake control module (EBCM) replacement, use the scan tool to perform the Tire Size Calibration procedure.
Replace the EBCM. Refer to Electronic Brake Control Module Replacement .Did you complete the replacement?		 Go to Step 6  -
6
  1. Turn OFF the ignition for 5 seconds.
  2. Turn ON the ignition while observing the traction off indicator.
Does the traction off indicator illuminate for approximately 2 seconds and then turn OFF?		 System OK Go to Step 3 
scientia non olet · About LEMON Manuals