Gear Shift Control Lever and Cable Removal and Installation

Gear Shift Control Lever and Cable Removal and Installation

Gear Shift Control Lever and Cable Components

CAUTION:

Touching a hot exhaust system component will cause a burn.

Do not perform any service work on the gear shift control cable until the exhaust system is cool.

Removal

1) Remove air cleaner assembly. Air Cleaner Assembly Removal and Installation
2) Remove battery and battery tray. Service and Repair
3) Remove battery bracket.
4) Remove center console box. Center Console Box Removal and Installation
5) Disconnect cable ends (5) from pivot (6) of gear shift control lever assembly.
6) Disconnect gear shift and gear select control cables (1) from gear shift control lever assembly (2) while pulling up quick joint (4).
7) Remove gear shift control lever assembly nuts (3) and remove gear shift control lever assembly from floor panel.
8) Remove clips of gear shift and gear select control cable, and then disconnect the cables from transaxle.
9) Remove cable grommet bolts and cable clamp nut, and then remove gear shift and select control cables from floor panel.






Installation

Reverse removal procedure noting the following points:

- Tighten each bolt and nut to specified torque. Gear Shift Control Lever and Cable Components
- Adjust gear select control cable. Adjustments