Signal Specification

All values given below are between the terminals stated in column 1 and terminal #A10 in column 2 (signal ground). This applies unless otherwise indicated in brackets.

NOTE: It is important to connect the breakout box and check the ground terminals before taking readings.

U=	DC voltage in volts (V)	U_low =	Voltage approximately 0 V
U_bat =	Battery voltage (V)	-	-

Fig 1: Identifying Connector (D) Terminals

Courtesy of VOLVO CARS CORPORATION

CONNECTOR A

Terminal	Breakout box terminal	Signal type	Ignition on	Ignition off	Other
#A1	#A1	30 supply	U = Ubat	U = Ulow	-
#A2	#A2	Reserve	-	-	-
#A3	#A3	Communication CAN L low speed network	During communication the voltage is 1.5-2.5 V		-
#A4	#A4	Communication CAN L low speed network	During communication the voltage is 1.5-2.5 V		-
#A5	#A5	Communication CAN_H low speed network	During communication the voltage is 2.0-3.5 V		-
#A6	#A6	Communication CAN_H low speed network	During communication the voltage is 2.0-3.5 V		-
#A7	#A7	Reserve	-	-	-
#A8	#A8	Reserve	-	-	-
#A9	#A9	Reserve	-	-	-
#A10	#A10	Power ground	U = Ulow	U = Ulow	-

Fig 2: Identifying Connector C

Courtesy of VOLVO CARS CORPORATION

CONNECTOR C

Terminal	Breakout box terminal	Signal type	Ignition on	Other
#C1	-	MOST input signal	-	Optical input signal
#C2	-	MOST output signal	-	Optical output signal