October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Signal Specification

All the values given below are between the terminals stated in column 1 and terminal #1 in column 2 (signal ground). This applies unless otherwise indicated in brackets.

NOTE: It is important to connect the breakout box and check the ground terminals before taking readings.

There may be several connections and connectors between the control module and components.

U=	DC voltage in volts (V)	U_AC =	AC voltage in volts (V)
U_bat =	Battery voltage (V)	f =	Frequency in Hertz (Hz)
U_low =	Voltage approximately 0 V	t =	Time in seconds
PWM =	Pulse width modulated signal as a %	-	-

Fig 1: Identifying Connector Terminals

GLL104035

Courtesy of VOLVO CARS CORPORATION

SIGNAL TABLE CONNECTOR A, PHONE MODULE (PHM)

Breakout box terminal	Control module terminal	Signal type	Ignition on	Idle	Other
#1	#A1	Diagnostic signal for switch ON CALL and SOS	U = 2 - 5 V	U = 2 - 5 V	Only Volvo On Call
#2	#A2	Input signal from switch ON CALL and SOS	ON CALL pressed in U= 2.6 V, SOS pressed in U= 2 V, otherwise U= 5 V	ON CALL pressed in U= 2.6 V, SOS pressed in U= 2 V, otherwise U= 5 V	Only Volvo On Call
#3	#A3	Voltage feed, lighting SOS-switch	U= 7 V	U= 7 V	Only Volvo On Call
#4	#A4	Voltage feed, lighting ON CALL-switch	U= 7 V	U= 7 V	Only Volvo On Call
#5	#A5	+30-feed	U_bat	U_bat	-
#6	#A6	Power ground	U=U_low	U=U_low	-
#7	#A7	Handset, voltage feed	U_bat	U_bat	-
#8	#A8	Handset, cradle signal	U= 3.34 V when the handset is in use, U= 1.9 V when the handset is not in use.	U= 3.34 V when the handset is in use, U= 1.9 V when the handset is not in use.	-
#9	#A9	-	-	-	-
#10	#A10	-	-	-	-
#11	#A11	CAN (L)	Digital signal	Digital signal	-
#12	#A12	CAN (H)	Digital signal	Digital signal	-
#13	#A13	Signal ground, switch ON CALL and SOS	U_low	U_low	Only Volvo On Call
#14	#A14	Signal ground, auxiliary microphone	U_low	U_low	Only Volvo On Call
#15	#A15	auxiliary microphone	U= 5 V	U= 5 V	Only Volvo On Call
#16	#A16	-	-	-	-
#17	#A17	Impact cable from SRS	U= 12 V at activated SRS-component, otherwise U= 0 V	U= 12 V at activated SRS-component, otherwise U= 0 V	-
#18	#A18	Handset, ground	U_low	U_low	-
#19	#A19	Handset, microphone	Alternating voltage at sound in microphone	Alternating voltage at sound in microphone	Difficult to measure
#20	#A20	Handset, speaker	Alternating voltage at sound in speaker	Alternating voltage at sound in speaker	Difficult to measure
#21	#A21	-	-	-	-
#22	#A22	-	-	-	-

Fig 2: Identifying Signal Table, Connector B

GLL101506

Courtesy of VOLVO CARS CORPORATION

SIGNAL TABLE CONNECTOR B, PHONE MODULE (PHM)

Breakout box terminal	Control module terminal	Signal type	Ignition on	Idle	Other
#21	#B1	Clock signal to SIM-card	Pound signal	Pound signal	-
#22	#B2	Signal ground, SIM-card	U_low	U_low	-
#23	#B3	Voltage feed, SIM-card	U=2.8 V	U=2.8 V	-
#24	#B4	Communication cable, SIM-card	Pulsed signal	Pulsed signal	-
#25	#B5	Control signal, SIM-card	Pulsed signal	Pulsed signal	-
#26	#B6	Diagnostic cable, SIM-card	U_low	U_low	-

Fig 3: Identifying Signal Table, Connector C

GLL139875

Courtesy of VOLVO CARS CORPORATION

SIGNAL TABLE CONNECTOR C, PHONE MODULE (PHM)

Breakout box terminal	Control module terminal	Signal type	Ignition on	Idle	Other
-	#C1	Telephone antenna	Antenna signal telephone	Antenna signal telephone	-
-	#C2	Antenna ground	U_low	U_low	-

Fig 4: Identifying 2-Pin Connector

GLL108088

Courtesy of VOLVO CARS CORPORATION

SIGNAL TABLE CONNECTOR D, PHONE MODULE (PHM)

Breakout box terminal	Control module terminal	Signal type	Ignition on	Idle	Other
-	#D1	MOST input signal	Optical input signal when the MOST network is activated	Optical input signal when the MOST network is activated	-
-	#D2	MOST signal	Optical output signal when the MOST network is activated	Optical output signal when the MOST network is activated	-

Fig 5: Identifying Signal Table, Connector B

GLL101506

Courtesy of VOLVO CARS CORPORATION

SIGNAL TABLE CONNECTOR SIM-CARD HOLDER

Breakout box terminal	Control module terminal	Signal type	Ignition on	Idle	Other
#21	#1	Clock signal to SIM-card	Pound signal	Pound signal	-
#22	#2	Signal ground, SIM-card	U_low	U_low	-
#23	#3	Voltage feed, SIM-card	U= 2.8 V	U= 2.8 V	-
#24	#4	Communication cable, SIM-card	Pulsed signal	Pulsed signal	-
#25	#5	Control signal, SIM-card	Pulsed signal	Pulsed signal	-
#26	#6	Diagnostic cable, SIM-card	U_low	U_low	-

Fig 6: Identifying Signal Table, Connector Volvo On Call Switch

GLL139891

Courtesy of VOLVO CARS CORPORATION

CONNECTOR VOLVO ON CALL

Breakout box terminal	Control module terminal	Signal type	Ignition on	Idle	Other
#13	#1	auxiliary microphone	U= 5 V	U= 5 V	-
#14	#2	Signal ground, auxiliary microphone	U_low	U_low	-
#15	#3	Voltage feed, lighting SOS-switch	U= 7 V	U= 7 V	-
#16	#4	Voltage feed, lighting ON CALL-switch	U= 7 V	U= 7 V	-
#17	#5	Diagnostic signal for switch ON CALL and SOS	U= 2-5 V	U= 2-5 V	-
#18	#6	Input signal from switch ON CALL and SOS	U= 2-5 V	U= 2-5 V	-
#19	#7	Signal ground, switch ON CALL and SOS	U_low	U_low	-

Fig 7: Identifying 5-Pin Connector

GLL104031

Courtesy of VOLVO CARS CORPORATION

SIGNAL TABLE CONNECTOR HANDSET

Breakout box terminal	Control module terminal	Signal type	Ignition on	Idle	Other
#21	#1	Handset, microphone	Alternating voltage at sound in microphone	Alternating voltage at sound in microphone	Difficult to measure
#22	#2	Handset, speaker	Alternating voltage at sound in microphone	Alternating voltage at sound in microphone	Difficult to measure
#23	#3	Handset, ground	U_low	U_low	-
#24	#4	Handset, cradle signal	U= 3.34 V when the handset is in use, U=1.9 V when the handset is not in use.	U= 3.34 V when the handset is in use, U= 1.9 V when the handset is not in use.	-
#25	#5	Handset, voltage feed	U_bat	U_bat	-