Installing The Climate Control Unit

Install: 

• the climate control unit
• the drainage hose from the heat exchanger housing

Install the pipes to the heat exchanger as follows:

see: HEAT EXCHANGER 

Install: 

• the 1 M8 screw securing the air conditioning (A/C) pipes to the evaporator in the engine compartment. Tighten
• both the air conditioning (A/C) hoses in their mountings below the right-hand spring strut turret
• the spacer that holds the heat exchanger and evaporator pipes apart
• the 2 screws and the right-hand half of the lead-in. Tighten
• the dashboard. Do not install the glove compartment. See: DASHBOARD
• the drain nipple on the radiator.

Fill with coolant and warm up the engine until the thermostat opens. Top up if necessary.

Check that the pipe coupling does not leak.