LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Volvo >> 2005 >> S60 AWD L5-2.5L Turbo VIN 59 B5254T2 >> Repair and Diagnosis >> Powertrain Management >> Computers and Control Systems >> Coolant Temperature Sensor/Switch (For Computer) >> Service and Repair >> Engine Temperature Sensor
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Engine Temperature Sensor






Engine temperature sensor

Removal

Engine temperature sensor, 5-cylinder




- Jack up the car.
- Remove protection cover from under engine.
- Drain the coolant as described in Replacing radiator/charge air cooler (CAC) Service and Repair.
- Lower the car.
- Release coolant hose from thermostat housing using pliers.
- Remove thermostat housing.
- Remove sensor.

Engine temperature sensor, 6-cylinder




- Jack up the car.
- Remove protection cover from under engine.
- Drain the coolant as described in Radiator / charge air cooler (CAC), replacement Radiator / Charge Air Cooler (CAC), Replacement.
- Lower the car.
- Loosen oil reservoir for servo pump as described in.
- Remove coolant reservoir and put it to one side.
- Remove screws and outer/upper timing-gear casing.
- Remove screws and wire channel.
- Disconnect connector.
- Remove 4 screws and thermostat housing.
- Remove sensor and wires.

Installation

Engine temperature sensor, 6-cylinder
- Install thermostat housing sensor.
- Position wires in slot on thermostat housing.

Note! The white marks should be positioned in lower opening of slot, from underneath.

- Position gasket on thermostat housing correctly and install thermostat housing using two of the screws.
- Position thermostat housing correctly and tighten the four screws.
- Position wire channel correctly and position wire in channel.
- Tighten screw on wire channel.
- Connect the connector.
- Install outer/upper timing-gear casing.
- Install coolant reservoir.
- Install oil reservoir for servo pump as described in.

Follow-on work, 6-cylinder
- Fill up coolant.
- Warm the engine until the thermostat opens.
Switch engine off and check the level. Re-fill if necessary.
- Check for leaks.
- Check in VIDA vehicle communication (read-out of parameter values), for current engine system, that the engine temperature shown appears correct.

Engine temperature sensor, 5-cylinder
Install in reverse order.

Follow-on work, 5-cylinder
- Fill up coolant.
- Warm the engine until the thermostat opens.
Switch engine off and check the level. Re-fill if necessary.
- Check for leaks.
- Check in VIDA vehicle communication (read-out of parameter values), for current engine system, that the engine temperature shown appears correct.

scientia non olet · About LEMON Manuals