ABS Control Module -J104- / ABS Hydraulic Unit -N55-, REMOVING AND INSTALLING: Installing

Install in reverse order of removal. Note the following.

• Remove the plugs on the new ABS Hydraulic Unit -N55- only when installing the corresponding brake line.
• Brake fluid may leak out if the plugs from the ABS Hydraulic Unit -N55- are removed beforehand and the unit may not be sufficiently filled or adequately bled.
• When installing the ABS Hydraulic Unit -N55-, make sure that the rubber bushings are not pushed out of the bracket.

-- Before assembling the holder for the ABS Hydraulic Unit -N55- in the bracket, spray the rubber bushings with Silicone Lubricant Spray :D 007 000 A2  .

-- Install the brake lines carefully with the Torque Wrench - Assembly Tool : V.A.G 1410/8  .

Fig 1: Identifying Torque Wrench - Assembly Tool

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Tightening Sequence: 

Fig 2: Brake Line Tightening Sequence

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the Brake Pedal Actuator : V.A.G 1869/2  .

-- Bleed the brake system. Refer to HYDRAULIC SYSTEM .

-- Code the radio.

-- Code the ABS Control Module -J104- using the => Vehicle diagnostic tester in the "Guided Fault Finding." 

While doing so, a basic setting for the Steering Angle Sensor -G85-, Transverse Acceleration Sensor -G200-, Longitudinal Acceleration Sensor -G251- and Brake Pressure Sensor 1 -G201- must be performed.