Driver Assistance Systems Front Camera, Calibrating: Notes
If the camera can no longer recognize the lane markings due to poor visibility, this could be caused by:
- Contamination or icing of the camera field of view present.
- Camera field of view is fogged up.
If heavy contamination at the inside of the windshield in the viewer of the camera is present, then the viewer of the camera must be cleaned by hand.
-- To do this, remove the camera and the lens and clean the windshield with cleaning solution. Remove the Driver Assistance Systems Front Camera -R242- and the lens.
If one of the following conditions is met, then the Driver Assistance Systems Front Camera -R242- must be calibrated:
- There is "no or false basic setting/adaption" active, listed in the DTC memory of the Driver Assistance Systems Front Camera -R242-.
- The windshield was removed and installed or replaced.
- The Driver Assistance Systems Front Camera -R242- was removed and installed or replaced.
- The bracket for the Driver Assistance Systems Front Camera -R242- was removed and installed or replaced.
- The lens was removed and installed or replaced.
- The wire for the Driver Assistance Systems Front Camera - R242- was replaced.
- The connector for the Driver Assistance Systems Front Camera - R242- was touched.
- Rear axle toe was adjusted.
- Changes to the vehicle suspension which changed the height were performed.
The Driver Assistance Systems Front Camera - R242- may only be calibrated using alignment equipment approved by VW/Audi.
Only the Setting Device Basic Set :VAS 6430/1 may be used to calibrate the Driver Assistance Systems Front Camera -R242-.
Special tools and workshop equipment required
- Setting Device - Basic Set :VAS 6430/1A
- Wheel Alignment Computer - Camera :VAS 701 001/1 , not illustrated
- Wheel Alignment Computer, not illustrated
- Vehicle Diagnostic Tester, not illustrated