Blind Spot Detection Control Modules -J1086- / -J1087-, Removing And Installing, Without GLI Equipment: Installing
WARNING: This page is about a different car, the 2025 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal, while noting the following:
-- If the Blind Spot Detection Control Module -J1086-/Blind Spot Detection Control Module 2 -J1087- was replaced, the following procedures may be necessary for the control module. Use the Vehicle Diagnostic Tester. .
- Software Update
- Data set download
- Coding
CAUTION:
For MY 2020 vehicles no calibration is necessary, because the calibration of the blind spot detection is automated.
| Nuts | Tightening Specification |
|---|---|
| Bolt | 2 Nm |
| Nut at the bracket | 5 Nm |
- Refer to OVERVIEW - BUMPER COVER .