Blind Spot Detection Control Modules -J1086- / -J1087-, Removing And Installing, With GLI Equipment: Removing
WARNING: This page is about a different car, the 2025 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the rear bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING .
-- Remove the bolt -1- for the bracket -5-.
-- Release the retaining tab -2- on the bracket -5-.
-- Remove the Blind Spot Detection Control Module 2 -J1087- -4- in -direction of the arrow- out of the bracket -5- until the connector -3- is accessible.
-- Release and disconnect the connector -3-.
-- Remove the nuts -6- for the bracket -5-.
-- Remove the bracket -5- from the body.