Test Requirements
Basic requirement
Condition
- Wheel alignment platform and alignment tester are checked and adjusted
- Suspension, wheel bearing and steering is without play or damage
- Tire tread may not show any uneven wear
- Tread depth difference may be no more than 2 mm on an axle
- The tire comes in contact with the specified tire pressure
- The vehicle must be unloaded
- The fuel tank must be filled all the way
- If a spare tire is present, it must be stored at the corresponding component location of the vehicle
- The vehicle tool kit stored at its component location
- During the alignment procedure the sliding plates and turntables must not be at their end stops
- The test equipment must be properly adjusted and attached to the vehicle; at the same time observe device manufacturer operating instructions
- Initial instruction by the alignment tester manufacturer