Test Requirements

Basic requirement

Condition

• Wheel alignment platform and alignment tester are checked and adjusted
• Suspension, wheel bearing and steering is without play or damage
• Tire tread may not show any uneven wear
• Tread depth difference may be no more than 2 mm on an axle
• The tire comes in contact with the specified tire pressure
• The vehicle must be unloaded
• The fuel tank must be filled all the way
• If a spare tire is present, it must be stored at the corresponding component location of the vehicle
• The vehicle tool kit stored at its component location
• During the alignment procedure the sliding plates and turntables must not be at their end stops
• The test equipment must be properly adjusted and attached to the vehicle; at the same time observe device manufacturer operating instructions
• Initial instruction by the alignment tester manufacturer