Safety Precautions

CAUTION:

If welding, soldering or cutting with spark-producing tools in foamed areas hazardous gases are produced.

- Never weld, solder or separate within 15 mm of molded foam parts.

- Perform the procedures with extraction.

Pay attention to the safety precautions. Refer to Safety Precautions SAFETY PRECAUTIONS AND REPAIR INFORMATION .

Welding and sanding must be carried out with ventilation.

Never weld and sand in any area at the same time.

Clean the work area regularly depending on the amount of dust.

Do not blow out the accumulated with compressed air.

Empty the extraction system after usage.

Follow all country-specific regulations regarding accident prevention and safety on the workplace.