Assembly Mount, Checking Adjustment: Procedure
WARNING: This page is about a different car, the 2025 Audi S3 and 2025 Audi A3 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
The following dimensions must be attained:
- The clearance between the engine support -2- and the engine mount -1- must be at least -a- = 10 mm.
- The casting edge on the engine support must be parallel to the engine mount support arm.
- Dimension -b- = dimension -b-.
- Distance of at least -a- = 10 mm can also be checked with corresponding round stock.
-- If the distance measured is too small or too large, adjust the subframe. Refer to ASSEMBLY MOUNT, ADJUSTING .
-- Make sure that the edges of the support arm and the transmission mount are parallel on the transmission side.
- Dimension -x- = dimension -x-.