Rear Axle Camber, Adjusting: Notes

Special tools and workshop equipment required

Insert Tool - 18mm :T10179

Fig 1: Insert Tool - 18mm
Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Loosen the nut -1- of the threaded connection on the upper transverse link at subframe.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Adjust the camber by turning the hex fitting of the eccentric screw -arrow-.

NOTE:

The maximum adjustment range is 90° to left or right of center position.

-- Tighten the nut -1-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Use the Insert Tool - 18mm :T10179 -A- for this.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Tighten the nut to 80 Nm using the Insert Tool - 18mm :T10179 .

-- After the nut -1- is tightened, check the camber value once more. Refer to AXLE ALIGNMENT SPECIFIED VALUES .