April 5, 2026: LEMON Manuals is launched! Read the announcement.

Front Axle Differential Lock, Installing

CAUTION:

When installing, guide and handle the front axle differential lock in a way that the installation position/transport position is kept. When tilting or turning the front axle differential lock oil can leak due to the bleeding, which can later on suggest a leak.

Install in the reverse order of removal while noting the following:

-- Slide the front axle differential lock completely onto the transmission. While doing this, join the flange shaft/front axle differential lock centrally with the differential. If necessary, turn on the flange shaft.

-- With the correct tooth position and central guiding, the front axle differential lock slides all the way up against the transmission.

-- Install any cable ties that were loosened or cut off during removal at their same location.

CAUTION:

Do not pull the front axle differential lock with the bolts against the transmission, otherwise the front axle differential lock will tilt and the mounting eyes could break.

-- Screw in the lower bolts -arrows- for the front axle differential lock and tighten them. Tightening specification: : Bolt.

Fig 1: Identifying Front Axle Differential Lock Lower Bolts

GWWN34-12017

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Screw in the upper bolts -arrows- for the front axle differential lock and tighten them. Tightening specification: : Bolt.

Fig 2: Identifying Front Axle Differential Lock Upper Bolts

GWWN34-12018

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Tighten the flange shaft with a countersunk bolt. Tightening specification: : Bolt.

Fig 3: Identifying Right Flange Shaft Countersunk Bolt, Socket And Key T10107

GWWA34-0615

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the Engine Support :T50015A .

GWWN26-11624

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the new bolts -1- for the pendulum support on the transmission. Refer to the appropriate service information .

GWWN40-10690

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the connector -arrow- on the Differential Locks Control Module -J647-.

Fig 4: Locating Axle Differential Lock Control Module Connector

GWWN34-12013

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the right drive axle. Refer to DRIVE AXLE, REMOVING AND INSTALLING .

Fig 5: AWD:

GWWA34-11312

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- If equipped, install the heat shield -1- for the drive axle -arrows-. Refer to Drive Axle .

-- Check the front axle differential lock fluid and fill if necessary. Refer to FRONT AXLE DIFFERENTIAL LOCK FLUID LEVEL, CHECKING .

-- Assemble the exhaust system. Refer to OVERVIEW - MUFFLER, GOLF FWD or OVERVIEW - MUFFLER, GOLF AWD, T-ROC "R" .

-- Install the noise insulation. Refer to OVERVIEW - NOISE INSULATION .