Special Tools
Special tools and workshop equipment required
- Thrust Piece: 3291/1 from the Subframe Bushing Tool Kit: 3291
- Spindle from the Bushing Tool Set: 3292
- Thrust pieces 3348 and 3348/1 from the Bearing Installer - Multiple Use: 3348
- -1- Internal Puller: VAS 251615
- -4- Counter Support: VAS 251623
Special tools and workshop equipment required
- Locking Pin Driver: 30-505
- Bearing Installer - Clutch Housing/Gearbox Bearing: V 554
- Bushing Installer - Rear Axle Beam: 3128
- Rear Bushing Tool - Press Piece: T40033/1
- Assembly Tool Kit - Traverse: T10030/5
- Bearing Installer - Component: 3346/2
- Bearing Installer - Control Arm Nut: 3346/3
Special tools and workshop equipment required
- Puller - Seal Lever: VW681
- Plate from the Puller - Flanged Shaft: T10037
- Seal Installer - Flange Shaft: T10049
- Shop Crane - Drip Tray: VAS6208
- Sealing Grease: G 052 128 A1
Special tools and workshop equipment required
- Puller - Seal Lever: VW681
- Slide Hammer Set: VW771
- Holding Fixture - Spacers: VW540/1B
- Transmission Support - Bolt: 3282/34
- Seal Installer - Flange Shaft: T10049
- Bridge from the Puller: VAS251415
Fig 4: Identifying Special Tools -- Rear Final Drive Flange/Drive Shaft Seal, Final Drive Installed, Replacing
Special tools and workshop equipment required
- Puller - Seal Lever: VW681
- Drive Sleeve: 30-20
- Counterhold - Crankshaft Sprocket: 3415
- Seal Installer - Shaft Seal Ring: T10019
- Three-Arm Puller: VAS251201
- Torque Wrench 1601: VAG1601
Special tools and workshop equipment required
- Used Oil Collection and Extraction Unit: SMN372500
- Multipoint Socket: T10035 and if necessary Bits for VAG1331/13: T10099
- Guide Pins: T10093
- Counterhold - Kit - Multiple Use: T10172
- Engine Support Device - Gearbox Bracket: T10346/1
- Engine Support: T50015A
- Torque Wrench 1783 - 2-10Nm: VAG1783
- Charging Device For BorgWarner Coupling 2: VAS6291A
- Charging Device For BorgWarner Coupling 2 - Adapter 2: VAS6291/1-2
- Charging Device For BorgWarner Coupling 2 - Adapter 3: VAS6291/3
- Engine and Gearbox Jack: VAS6931 or : VAG 1383A
- -1- Internal Puller: VAS251601
- -4- Counter Support: VAS251621
- Not illustrated:
- Torque Wrench 1331 5-50Nm: VAG1331
- Torque Wrench 1332 40-200Nm: VAG1332
- Shop Crane - Drip Tray: VAS6208