MULTIFUNCTION Transmission Range Switch, Adjusting

Special tools and workshop equipment required 

• Gauge - Multi Function Switch :T10173 

-- Move the selector lever into "N".

-- Do not bend the selector lever cable.

Adjustment Requirements:

• The selector lever cable is removed from the selector lever.
• The selector shaft is in "N".
• The bolts on the Multifunction Transmission Range Switch -F125- are loosened.
• The selector lever is removed from the front selector shaft

-- Install the :T10173  on the selector shaft -2- and turn the Multifunction Transmission Range Switch -F125- -1- until the :T10173  locks onto the tab on the connector on the Multifunction Transmission Range Switch -F125-.

Fig 1: Adjustment Tool Attached Onto Shift Rod

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Use the bolt -3- to secure the :T10173  to the selector shaft -2-.

-- Tighten the bolts -arrows- to the tightening specification.

-- Remove the :T10173  .

-- Further installation is performed in reverse order of removal. Refer to , Installing .

Tightening Specifications 

• Refer to OVERVIEW - VALVE BODY