Overview - Attachments For Heater And A/C Unit And Air Intake Housing
NOTE:
There are different versions and manufacturers of the heater and A/C units. Individual components of the different heater and A/C units are similar but not the same. Interchanging components from different manufacturers is not permitted. Refer to Parts Information.
A "Valeo" air intake housing is shown in the following illustration. Refer to IDENTIFICATION for the different manufacturers' distinguishing characteristics of the heater and A/C units.
Fig 1: Exploded View Of Air Intake Duct, Dust And Pollen Filter, Fresh Air Blower, Door Control Components
- Plastic Screw or Plug (Depending on Version)
- Quantity: 2
- 0.3 Nm
- Partition
- Removing and Installing. Refer to PARTITION, REMOVING AND INSTALLING .
- Fresh Air Blower Housing Upper Section
- Bolt
- Quantity: 2
- 1 Nm
- Air Intake Duct
- With fresh air and air recirculation door
- There are different versions. Refer to the Parts Information.
- Removing and Installing. Refer to AIR INTAKE DUCT, REMOVING AND INSTALLING .
- Do not disassemble
- Dust, Fresh and Air Recirculation Door Adjuster
- Only for vehicles with Climatronic.
- Removing and Installing. Refer to AIR DISTRIBUTION DOOR ADJUSTER, REMOVING AND INSTALLING .
- Bolt
- Only for vehicles with Climatronic.
- Quantity: 2
- 1 Nm
- Actuator
- To check, use the Vehicle Diagnostic Tester
in the "Guided Fault Finding"
function. Refer to
Wiring Diagram.
Electric-manual A/C system
- Recirculation Door Motor -V113- without position sensor; with end switches in the end stops. Refer to Wiring Diagram.
- Removing and Installing. Refer to Recirculation Door Motor -V113-, REMOVING AND INSTALLING .
Climatronic:
- Fresh Air/Recirculating Air/Back Pressure Door Motor -V425- with Fresh Air/Recirculating Air/Back Pressure Door Motor Position Sensor -G644-
- Removing and Installing. Refer to Fresh Air/Recirculating Air/Back Pressure Door Motor -V425-, REMOVING AND INSTALLING .
- To check, use the Vehicle Diagnostic Tester
in the "Guided Fault Finding"
function. Refer to
Wiring Diagram.
- Bolt
- Quantity: 2
- 1 Nm
- Dust and Pollen Filter
- There are different versions. Refer to the Parts Information.
- Replacement interval. Refer to MAINTENANCE SCHEDULES .
- Removing and Installing. Refer to DUST AND POLLEN FILTER, REMOVING AND INSTALLING .
- Cover
- For dust and pollen filter
- Fresh Air Blower -V2-
- To check, use the Vehicle Diagnostic Tester in the "Guided Fault Finding" function. Refer to Wiring Diagram.
- Removing and Installing. Refer to Fresh Air Blower -V2-, REMOVING AND INSTALLING .
- Fresh Air Blower Control Module -J126-
- To check, use the Vehicle Diagnostic Tester in the "Guided Fault Finding" function. Refer to Wiring Diagram.
- Removing and Installing. Refer to Fresh Air Blower Control Module -J126-, REMOVING AND INSTALLING .
- Bolt
- Quantity: 2
- 1 Nm