Evaluating Test Results
Evaluating the battery test results for the warranty and service tests
| Battery test result | Steps |
|---|---|
| Battery good | No action on the battery |
| Battery good - recharge | Charge battery. Refer to BATTERY CHARGE . If necessary, search for the cause of the discharging |
| Perform a current draw test | Perform a current draw test. Refer to CURRENT DRAW TEST . Charge the battery completely and test again. Refer to BATTERY CHARGE . |
| Replace the battery | Disconnect the battery and test again. The result "replace the battery" can occur due to a weak cable contact. |
| Battery cell faulty - replace | Replace the battery |
| Check the connection | Connect the cable directly to the battery and not to the battery jump start terminal. |
| Battery depleted | Replace the battery |
Evaluating the battery test results for the maintenance test
| Battery test result | Steps |
|---|---|
| Battery good | No measure |
| Charge the battery immediately | Fully charge the battery. Refer to BATTERY CHARGE . |
| Mark as defective | Mark as defective. |
| Check the tester connection | Disconnect the battery and test again. The result "check the tester connection" can occur because the cable contact is weak. |
| Check the connection | Connect the cable directly to the battery and not to the battery jump start terminal. |
| Noises | Wait until the measured value appears in the display. |
| Battery depleted | Replace the battery |