Seals For ATF Cooler, Replacing: Installing
Install in the reverse order of removal while noting the following:
-- Replace the O-rings -2-.
- When inserting the ATF cooler -1- pay attention that the O-rings -2- are seated correctly.
- The O-rings must be seated correctly in the groove of the ATF cooler.
CAUTION:
Risk of leaks due to twisting the O-rings.
- It is not allowed to push the ATF cooler horizontal on the sealing surface.
- Pivot the ATF cooler from above on to the transmission.
NOTE:
To straighten the rear bolts -arrows- the : VAS6947 can be used.
-- Attach the selector lever cable to the transmission and adjust it. Refer to SELECTOR LEVER CABLE, REMOVING AND INSTALLING .
-- Check the ATF level. Refer to ATF .