BLIND SPOT DETECTION CONTROL MODULE -J1086- / Blind Spot Detection Control Module 2 -J1087-, REMOVING AND INSTALLING: Installing
Install in the reverse order of removal while noting the following:
-- If the Blind Spot Detection Control Module -J1086-/Blind Spot Detection Control Module 2 -J1087- was replaced, the following procedures may be necessary for the control module. Use the Vehicle Diagnostic Tester .
- Software Update
- Data set download
- Coding
CAUTION:
For MY 2020 vehicles no calibration is necessary, because the calibration of the blind spot detection is automated.
| Nuts | Tightening Specification |
|---|---|
| Nut at the bracket | 3.5 Nm |
- Refer to OVERVIEW - BUMPER COVER .