Overview - Assembly Mounts
- Engine Support
- Removing and Installing. Refer to ENGINE SUPPORT, REMOVING AND INSTALLING .
- Bolt
- Replace after removing
- Tightening specification, sequence and allocation. Refer to Fig 2.
- Engine Mount
- With support arm
- Removing and Installing. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .
- Bolt
- 20 Nm +90°
- Replace after removing
- Double Bolt
- 40 Nm +90°
- Replace after removing
- Bolt
- 40 Nm +90°
- Replace after removing
- Bolt
- 60 Nm +90°
- Replace after removing
- Pendulum Support
- Removing and Installing. Refer to PENDULUM SUPPORT, REMOVING AND INSTALLING .
- Tightening sequence and tightening specification. Refer to Fig 3.
- Bolt
- Replace after removing
- Tightening specification and sequence. Refer to Fig 3.
- Bolt
- Replace after removing
- Tightening specification and sequence. Refer to Fig 3.
- Bolt
- Replace after removing
- Tightening specification and sequence. Refer to Fig 3.
- Bolts
- 60 Nm +90°
- Replace after removing
- Bolts
- 50 Nm + 90°
- Replace after removing
- Transmission Mount
- With support arm
- Removing and Installing. Refer to TRANSMISSION MOUNT, REMOVING AND INSTALLING .
- Bolt
- 50 Nm + 90°
- Replace after removing
Engine Support - Tightening Specification and Sequence
NOTE:
Replace the bolts that were tightened with an additional turn.
-- Tighten the bolts in the steps in the sequence shown:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -1 to 3- | 40 Nm |
| 2. | -1 to 3- | 90° additional turn |
Pendulum Support Threaded Connection
NOTE:
Replace bolts that were tightened with an additional turn after removing them.
-- Tighten the bolts in the steps in the sequence shown:
Tightening Specifications
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1 | -2 and 3- | 50 Nm |
| 2 | -1- | 130 Nm |
| 3 | -1 to 3- | 90° additional turn |