A/C Compressor, Removing And Installing: Removing

-- Remove the noise insulation under the engine. Refer to OVERVIEW - NOISE INSULATION .

Remove the right front wheel housing liner if necessary. Refer to FRONT WHEEL HOUSING LINER, REMOVING AND INSTALLING .

-- Remove the ribbed belt. Refer to RIBBED BELT, REMOVING AND INSTALLING (1.5L) or RIBBED BELT, REMOVING AND INSTALLING (2.0L) .

Vehicles with Refrigerant R134a

-- Discharge the refrigerant circuit. Refer to the appropriate Service Information .

Vehicles with Refrigerant R1234yf

-- Discharge the refrigerant circuit. Refer to REFRIGERANT CIRCUIT, DISCHARGING .

Continuation for all vehicles

CAUTION:

Danger of frostbite due to refrigerant coming out under pressure.

Frostbite on the skin and other parts of the body is possible.

- Wear safety gloves.

- Wear protective eyewear.

- Extract refrigerant and open the refrigerant circuit immediately.

- If more than 10 minutes have elapsed since evacuating the refrigerant and the refrigerant circuit was not opened, evacuate the refrigerant again. Evaporation can cause pressure to develop in the refrigerant circuit.

-- For all following procedures immediately seal all the open lines and connections with clean plugs from the Engine Bung Set: VAS 6122 .

-- Remove the bolts -3-.

Fig 1: Connector And A/C compressor

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the refrigerant lines -2- and -4- from the A/C compressor -1-.

-- Disconnect the connector -6-.

Vehicles with A/C Clutch -N25-

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the connector -1-.

Continuation for all vehicles

Fig 2: Connector And A/C compressor

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolts -5-.

-- Remove the A/C compressor -1-.