Blind Spot Detection Control Module -J1086- /Blind Spot Detection Control Module 2 -J1087-, REMOVING AND INSTALLING, WITHOUT GLI EQUIPMENT: Installing
Install in the reverse order of removal while noting the following:
-- If the Blind Spot Detection Control Module -J1086- /Blind Spot Detection Control Module 2 -J1087- - was replaced, the following procedures may be necessary for the control module. Use the Vehicle Diagnostic Tester
- Software Update
- Data set download
- Coding
CAUTION:
For vehicles of MY 2020 no calibration is necessary, because the calibration of the blind spot detection is done automatically
| Nuts | Tightening Specification |
|---|---|
| Bolt | 2 Nm |
| Nut at the bracket | 5 Nm |
- Refer to OVERVIEW - BUMPER COVER .