Shift Mechanism, Servicing: Notes
Cable retainer allocation
The holes in the cable retainers have different diameters.
| Cable retainer for: | Dimension "a" |
|---|---|
| -1- shift cable to gearshift lever | 8.5 mm |
| -2- selector cable to selector relay lever | 10 mm |
Selector lever/selector relay lever installed position
- Shift Lever
- Clip
- The selector relay lever fits into the sliding rail on the transmission selector lever via the sliding shoe -arrow-.
Selector relay lever: lubricate the following areas very carefully when installing.
- Shaft -A- on the selector relay lever -arrows- ; quantity of grease: 0.2 grams
- Refer to the Parts Information for the grease allocation.
Gearshift lever: lubricate the following areas very carefully when installing.
- Gearshift lever glide track -B-, fits into the selector relay lever.
- Cable retainer locating bore.
- Refer to the Parts Information for the grease allocation.
- The selector relay lever and selector lever in the illustration may differ from the original part.
Shift Lever, Installing
-- When positioning the transmission shift lever, make sure the tooth gap -arrow A- is placed over the missing selector shaft teeth -arrow B-.
Selector Relay Lever, Removing and Installing
-- Pull the cable retainer all the way forward in the -direction of the arrow 1- and then unlock to the left in the -direction of the arrow 2-.
-- Push the selector relay lever forward and guide the selector cable out of the cable retainer.
The cable retainer may be removed only when the selector relay lever is removed. Refer to Figure.
Remove and install the selector relay lever together with the cable retainer