Overview - Fuel Delivery Unit/Fuel Level Sensor, AWD Vehicles
- Fuel Pump Control Module -J538-
- Check using the Vehicle Diagnostic Tester .
- Refer to Fuel Pump Control Module -J538-, REMOVING AND INSTALLING
- Connector
- For Fuel Pump Control Module -J538-
- Connector
- For Transfer Fuel Pump -G6-
- Connector
- For Fuel Level Sensor -G- and Fuel Level Sensor 2 -G169-
- Locking Ring
- Loosen and tighten using the Wrench - Fuel Sending Unit: T10202
- 110 Nm
- Sealing Flange
- Seal
- Replace after removing
- Install dry
- Fuel Level Sensor 2 -G169-
- Check eclectically using the Vehicle Diagnostic Tester .
- Refer to Fuel Level Sensor 2 -G169-, REMOVING AND INSTALLING
- Mount with Suction Jet Pump
- No replacement part
- Welded to the fuel tank
- Function. Refer to SUCTION JET PUMP, REMOVING AND INSTALLING .
- Fuel Level Sensor -G-
- Check eclectically using the Vehicle Diagnostic Tester .
- Refer to Fuel Level Sensor -G-, REMOVING AND INSTALLING
- Fuel Delivery Unit
- With the Transfer Fuel Pump -G6-
- With integrated fuel filter; the fuel filter cannot be replaced separately
- Removing and Installing. Refer to FUEL DELIVERY UNIT/FUEL LEVEL SENSOR, REMOVING AND INSTALLING .
- Seal
- Replace after removing
- Install dry
- Locking Ring
- Loosen and tighten using the Wrench - Fuel Sending Unit: T10202
- 110 Nm
- Fuel Line
- To the engine
- Do not kink
Overview - Fuel Delivery Unit/Fuel Level Sensor, Vehicles with Parking Heater:
- Fuel Delivery Unit
- With the Transfer Fuel Pump -G6-
- With integrated fuel filter; the fuel filter cannot be replaced separately
- Refer to FUEL DELIVERY UNIT/FUEL LEVEL SENSOR, REMOVING AND INSTALLING
- Clamp
- Replace after removing
- Secure the hose connections with hose clamps that correspond to the model.
- Clamp
- Replace after removing
- Secure the hose connections with hose clamps that correspond to the model.
- Fuel Line
- To the Metering Pump -V54-
- Refer to PARKING/AUXILIARY HEATER FUEL LINE, REMOVING AND INSTALLING
- Grommet
- Check for damages
- Fuel Line
- To the engine
Fuel Delivery Unit Installation Position
- The arrow -3- on the fuel tank must point to the mark -2- on the sealing flange -1-.