Test Requirements

• Check suspension, wheel bearing and steering for excessive play and damage.
• Tread depth difference may be no more than 2 mm on an axle.
• Tires inflated to prescribed pressure
• Vehicle curb weight
• Fuel tank must be full.
• Spare tire and vehicle tools are installed in appropriate position in vehicle.
• The windshield washer fluid reservoir must be full.
• Make sure that the sliding plate and turntable are not touching the end stop during the measurement.

Note!

• The test equipment must be properly adjusted and attached to the vehicle; observe device manufacturer operating instructions.

If necessary, contact the manufacturer of the alignment equipment for familiarization with the proper use of the equipment.

The vehicle alignment platforms and wheel alignment computer can lose their calibration over a period of time.

Wheel alignment platforms and wheel alignment computers must be serviced and calibrated at least once a year.

-- Handle highly sensitive units with care.