Steering Column, Removing And Installing: Removing

CAUTION:

The steering column is delivered only as a complete replacement part. Servicing is not possible.

The Electronic Steering Column Lock Control Module -J764- can be removed and installed. Refer to Electronic Steering Column Lock Control Module -J764-, REMOVING AND INSTALLING .

CAUTION:

Before starting work on electrical equipment and removing the steering wheel, the following conditions must be fulfilled:

The technician must discharge themselves of static electricity. This is done by touching grounded metal parts, for example, water lines, heater pipes, metal supports or a workshop hoist.

If this not done, the Electronic Steering Column Lock Control Module -J764- could fail later.

Disconnect the battery. Refer to BATTERY, DISCONNECTING AND CONNECTING .
The wheels must be in the straight position.

-- Bring wheels in the straight position.

-- Pull the lever on the side of the steering column downward.

-- Push the steering column as far down as possible and remove it.

-- Push the lever on the side of the steering column upward again.

-- Remove the airbag unit. Refer to OVERVIEW - DRIVER SIDE AIRBAG .

-- Remove the steering wheel. Refer to STEERING WHEEL, REMOVING AND INSTALLING .

-- Remove the upper steering column trim panel. Refer to UPPER STEERING COLUMN TRIM PANEL, REMOVING AND INSTALLING .

-- Remove the lower steering column trim panel. Refer to LOWER STEERING COLUMN TRIM PANEL, REMOVING AND INSTALLING .

-- Remove the steering column switch module. Refer to STEERING COLUMN SWITCH MODULE, REMOVING AND INSTALLING .

-- Remove the footwell vent under the steering column. Refer to OVERVIEW - AIR ROUTING AND AIR DISTRIBUTION IN VEHICLE INTERIOR .

-- Release and detach the connector -3- at the Electronic Steering Column Lock Control Module -J764- -1-. Refer to Electronic Steering Column Lock Control Module -J764-, REMOVING AND INSTALLING .

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Release the tab in direction of -arrow- using a small screwdriver.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the cable guide -1- forward from the metal tab.

-- Release the tabs -arrows- on the cable guide -1- with a small screwdriver.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the cable guide -1- downward from the steering column.

-- Remove the lower cable bracket -2-.

-- For this, release the lower cable bracket -1- at the tabs in the direction of -arrow-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

CAUTION:

The tabs are directly anchored in the steering column and are located between the bracket -1- and the steering column.

-- Remove the cable bracket -1- downward.

-- Set the wire for the steering column aside.

-- Remove the bolts -1-. Fold the footwell trim panel -2- in direction of the arrow into the vehicle interior.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolt -1- from the universal joint -2-. Then remove the universal joint in direction of -arrow-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

CAUTION:

Damage to the steering column due to an incorrect procedure. If the universal joint is separated from the steering gear do not perform the following procedures:

- Connect the battery.

- Activate drive ready mode.

- Turn the steering gear.

- Turn the steering column.

-- Remove the bolt -1 through 4- and at the same time hold the steering column -5-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

LHD Vehicles:

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the steering column -1- at the crossmember from the guides -2 and 3- in direction of the driver seat.

RHD Vehicle:

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the steering column -1- at the crossmember from the guides -2 and 3- in direction of the driver seat.

Continuation for All Vehicles:

CAUTION:

Refer to STEERING COLUMN, HANDLING AND TRANSPORTING for the correct handling and transport of steering column.