Overview - Front Axle Differential Lock Components
- Front Axle Differential Lock
- Removing. Refer to FRONT AXLE DIFFERENTIAL LOCK, REMOVING .
- Installing. Refer to FRONT AXLE DIFFERENTIAL LOCK, INSTALLING .
- Seal
- for the flange shaft in front axle differential lock
- Replacing with front axle differential lock removed. Refer to RIGHT FLANGE SHAFT SEAL IN FRONT AXLE DIFFERENTIAL LOCK, REPLACING
- Support Washer
- No replacement part
- Seal
- Between the front axle differential lock and the transmission
- Replacing with front axle differential lock removed. Refer to SEAL BETWEEN FRONT AXLE DIFFERENTIAL LOCK AND TRANSMISSION, REPLACING ON FRONT AXLE DIFFERENTIAL LOCK
- Bolts
- M6: 9 Nm
- M5: 6 Nm
- Operating Speed Throttle Actuator -V181-
- Removing and Installing. Refer to All-Wheel Drive Clutch Pump -V181-, REMOVING AND INSTALLING .
- O-Ring
- For Operating Speed Throttle Actuator -V181-
- Coat the O-rings with Front Axle Differential Lock Fluid
- Differential Locks Control Module -J647-
- Removing and Installing. Refer to Differential Locks Control Module -J647-, REMOVING AND INSTALLING .
- Bolts
- 9 Nm
- Ball Bearing
- for the flange shaft in front axle differential lock
- Replacing with front axle differential lock removed. Refer to FLANGE SHAFT BALL BEARING, REPLACING
- Circlip
- For ball bearing
- Seal
- For the flange shaft
- Replacing with front axle differential lock installed. Refer to RIGHT SEAL ON OUTER FRONT AXLE DIFFERENTIAL LOCK, REPLACING
- Flange Shaft
- Removing and Installing. Refer to Figure.
- Circlip
- for the flange shaft in front axle differential lock
- Replace after removing the flange shaft
- Bolt
- With an M8 threaded pin
- 40 Nm
- Bolt
- With an M8 threaded pin
- 40 Nm
- Fluid Drain Plug
- Replace after removing
- with an o-ring
- Coat the O-ring with Front Axle Differential Lock Fluid
- 15 Nm
- Fluid Filler Plug
- Replace after removing
- with an o-ring
- Coat the O-ring with Front Axle Differential Lock Fluid
- 15 Nm