Overview - Bevel Box
WARNING: This page is about a different variant/trim than selected.
- Bolt
- Tightening specification. Refer to OVERVIEW - DIFFERENTIAL .
- Heat Shield
- For drive axle
- Nut
- Quantity: 2 or 3
- Tightening specification. Refer to OVERVIEW - DRIVE AXLE .
- Bolt
- only on bevel box "0CN" for the heat shield at the bevel box
- Tightening specification. Refer to the appropriate Service Information .
- Heat Shield
- For driveshaft
- only on bevel box "0CN"
- Bolt
- only on bevel box "0CN" for the heat shield at the bevel box
- Tightening specification. Refer to the appropriate Service Information .
- Bevel Box
- Removing. Refer to BEVEL BOX, REMOVING .
- Installing. Refer to BEVEL BOX, INSTALLING .
- Characteristics of the bevel box. Refer to BEVEL BOX, DIFFERENTIATING .
- Bolt
- Quantity: 4
- Replace after removing
- Tightening specification. Refer to OVERVIEW - DIFFERENTIAL .
- Transmission Support
- There are different versions. Refer to the Parts Information for the allocation.
- Bolt
- Quantity: 2
- Transmission support to bevel box
- Tightening specifications and sequence:
- Bevel box "0AV" and "0CN". Refer to Figure.
- Bolt
- Quantity: 2
- Transmission support to engine
- Tightening specifications and sequence:
- Bevel box "0AV" and "0CN". Refer to Figure.