Bumper Cover Painting Instructions In Lane Change Assistance Control Module Area
Bumper Cover in the Area of the Lane Change Assistance Control Module
Left side shown the right side is a mirror image depending on the vehicle model and equipment
To avoid malfunctions of the control module (lane change assistance) -1- pay attention to the following parameter when painting the bumper cover -2-.
- Do not exceeded the maximum paint coat thickness of 150 μm in the area of the control modules (lane change assistance) -1-.
- A plastic repair may not be preformed in this area in a vicinity of minimum dimension -x- = 25 cm.
- Smoothing work may not be preformed in this area in a vicinity of minimum dimension -x- = 25 cm.
- Triple panting is not permitted on the bumper cover -2-.
- Before beginning painting check using a grinding pattern in the adjacent area if the bumper cover -2- was already repainted.
- Spot repair of the area of the control modules (lane change assistance) -1- is not permitted.