Overview - EVAP System, From 10/2018
- Bolt
- Replace after removing
- 20 Nm
- EVAP Canister
- Component location: right rear
- Removing and Installing. Refer to EVAP CANISTER, REMOVING AND INSTALLING, FROM 10/2018 .
- Air Filter
- Component location: at the right rear in the wheel housing under the wheel housing liner
- Clipped in on the EVAP canister -item 2-
- Removing and Installing. Refer to EVAP CANISTER AIR FILTER, REMOVING AND INSTALLING .
- Hose Clamps
- Connecting Hose
- From the air filter to the Fuel Tank Leak Detection Module -GX36-.
- Check for debris and clean if necessary.
- Leak Detection Pump
- Component location: right rear at the EVAP canister
- Removing and Installing. Refer to LEAK DETECTION PUMP, REMOVING AND INSTALLING, FROM 10/2018 .
- Grommet
- Bolt
- Quantity: 3
- 1.5 Nm
- Bleeder Line
- From the fuel tank
- Connector Couplings, Disconnecting and Connecting. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
- Bleeder Line
- To the EVAP Canister Purge Regulator Valve 1 -N80-
- Connector Couplings, Disconnecting and Connecting. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
- Clipped to the underbody