Peripheral Camera System, Calibrating

-- The vehicle must be on a level surface.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Roll out the Calibration System:VAS 721 001  at the left and right near the vehicle.

• The arrows -1- on the calibration patterns point in the vehicle direction of travel.

-- Install the rear and front clamping strip on the calibration patterns of the Calibration System:VAS 721 001  .

-- Align the crosshairs -2- to the front axle of the vehicle (center front wheel).

-- Align both calibration patterns parallel. The vehicle must be located in the center between both calibration patterns.

Pay attention to the following measurement requirements:

• Dimension -a- 2000 to 2500 mm (78.74 to 98.43 in.) ± 5 mm (0.20 in.), front and rear the same
• Dimension -b- (distance from front wheel contact surface to the calibration pattern) must be even on both sides.
• Dimension -c- (distance from rear wheel contact surface to the calibration pattern) must be even on both sides.

-- Set-up the requirement for the vehicle.

-- Connect the Vehicle Diagnostic Tester.

-- Perform the calibration using the Vehicle Diagnostic Tester.