Knock Sensor 1 -G61-, Removing And Installing

WARNING: This page is about a different variant/trim than selected.

NOTE:

The Knock Sensor 1 -G61- is located under the exhaust manifold.

Removing

-- Disconnect the connector -3-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the cable -1- from the bracket -2-.

-- Remove the right front wheel housing liner. Refer to FRONT WHEEL HOUSING LINER, REMOVING AND INSTALLING .

-- Bend up the heat shield -2-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolt -3- and then the Knock Sensor 1 -G61-.

Installing:

Install in reverse order of removal while noting the following:

Tightening Specification