TPMS Reminder Reset - Procedure 05
NOTE:
This procedure is for an Indirect TPM System. Vehicles without tire pressure sensors installed in the tires.
After the following work and/or changes and with the ignition switched on, the Tire Pressure Monitoring System SET button must be pressed until the confirmation chime sounds:
- Tire pressure change.
- Removal and re-installation of same tires.
- A change of one or more tires.
- After rotating tires.
After every change at wheels, the SET button (near the shift lever, or inside the glove compartment) must be pressed (for at least 2 seconds, and not more than 30 seconds), with ignition switched on and vehicle standing still, until a signal tone sounds. The signal tone confirms the basic setting.
NOTE:
After a low tire pressure warning, the vehicle must stand and must not be driven for at least 1 minute before the SET button can be used to store a new benchmark tire pressure.