Information Electronics Control Module 1 -J794-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2023 Volkswagen Atlas. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn off the ignition and all electrical equipment.

-- Move the ignition key outside of the vehicle to prevent the ignition from switching on unintentionally.

-- Open the glove compartment.

-- Remove any data storage device still in the Information Electronics Control Module 1 -J794-.

-- Insert two of the Radio Removal Tool:T10057 into the release slots on the Information Electronics Control Module 1 -J794- -1- until they engage.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

The points at the grip eyelets of the Radio Removal Tool:T10057 must face outward.

-- Remove the Information Electronics Control Module 1 -J794- -1- from the glove compartment at the Radio Removal Tool:T10057 grip eyes.

-- Release and disconnect the connectors from the Information Electronics Control Module 1 -J794- -1-.

Equipment levels with MOST bus

-- Insert the Fiber-Optic Repair Set - Connector Protective Caps:VAS 6223/9 -1- onto the MOST bus connector -2-.

Fig 1: Fiber-Optic Cable Harness Connector And Protective Cap For Cable Connector VAS 6223/9

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

All Equipment Levels

-- Press the locking tabs on the Information Electronics Control Module 1 -J794- and remove the Radio Removal Tool: T10057 .