April 5, 2026: LEMON Manuals is launched! Read the announcement.

Rear Axle Camber, Adjusting

WARNING: This page is about a different car, the 2023 Volkswagen Atlas. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Torque Wrench, 40-200Nm:VAG1332A

Fig 1: Identifying Torque Wrench 1332
Courtesy of AUDI OF AMERICA, LLC
Insert Tool - 18mm:T10179

Fig 2: Insert Tool - 18mm
Courtesy of AUDI OF AMERICA, LLC

-- Loosen the nut -A- of the threaded connection on the upper transverse link at subframe.

Fig 3: Identifying Upper Transverse Link Threaded Fastener Nut

GWWN44-10035

Courtesy of AUDI OF AMERICA, LLC

-- Adjust the camber by turning the hex fitting of the eccentric screw -arrow-.

NOTE:

The maximum adjustment range is 90° to left or right of center position.

-- Tighten the nut -A-.

Fig 4: Identifying Upper Transverse Link Threaded Fastener Nut

GWWN44-10035

Courtesy of AUDI OF AMERICA, LLC

-- Use the :T10179 for this.

Fig 5: Identifying Nut & T10179

GWWA44-0185

Courtesy of AUDI OF AMERICA, LLC

Tighten the Nut to 80 Nm Using the :T10179 .

-- Check the camber value again after tightening the nut -A-.

-- After the nut -A- is tightened, check the camber value once more. Refer to AXLE ALIGNMENT SPECIFIED VALUES .

Tightening Specifications

Refer to OVERVIEW - TRANSVERSE LINK