Selector Lever Handle, Removing And Installing: Removing

WARNING: This page is about a different car, the 2023 Volkswagen Atlas. However, it is still accessible from the selected car via links, so may be relevant.

-- Move the selector lever into "D" position.

It is not necessary to pull out the button -arrow- manually. The button locks in the installation position by itself when the handle is removed.

Fig 1: Handle With Button In Front

Courtesy of AUDI OF AMERICA, LLC

-- Insert the Wedge Set:T10383/2 -A- at the front on the left and right sides between the center console and shift cover as shown and carefully pry out the shift cover in direction of -arrows-.

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector.

-- Cut the clamp -arrow- under the boot with a side cutter.

Fig 2: Identifying Clamp

Courtesy of AUDI OF AMERICA, LLC

-- Pull the knob up without pressing the button.

NOTE:

Do not push the button once the handle has been removed otherwise it will not be possible to remove the handle again.