Driveshaft, Removing And Installing: Notes

WARNING: This page is about a different car, the 2023 Volkswagen Atlas. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Counterhold - Multiple Use:T10172A

Fig 1: Counterhold - Kit - Multiple Use T10172
Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
Engine and Gearbox Jack:VAS6931 or :VAG1383A

Fig 2: Engine and Gearbox Jack VAS6931 or VAG1383A
Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

Perform work on driveshaft on a two-column workshop hoist if possible.

Label the position of all the parts to each other before removing them. Install in the same position otherwise the imbalance will be excessive and the bearings could get damaged causing rumbling noises.

Do not bend the driveshaft, only store and move when fully extended.

Do not allow the driveshaft to >>hang down<< during removal. Always support it.

Always remove or install the driveshaft horizontally with respect to the drive flange.