Overview - FLANGING Tool

WARNING: This page is about a different car, the 2023 Volkswagen Atlas. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Brake Line Tool Kit:VAS6056

Fig 1: Identifying Brake Line Tool Kit
Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
Brake Filling and Bleeding Equipment:VAS6860

Flare the brake lines with 5 mm outer pipe diameter using the :VAS6056 without damaging the coating. This allows for partial sections of the brake lines to be inexpensively replaced in certain cases.

NOTE:

Brake lines must not be bent more than 90°, otherwise they kink or deform causes unacceptable constriction in the wire cross-section.

Disconnect the brake lines preferably at the underbody.

The position of intermediate pieces should be selected so that they cannot rub against moving parts.

Do not lubricate the spindle, clean only with mineral spirits.

List of Individual Tools:

Fig 2: Brake Line Repair Tools

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Brake Line Tool Kit - Flanging Tool:VAS6056/1
- The Clamp Jaws:VAS6056/6 are included in the Brake Line Tool Kit - Flanging Tool:VAS6056/1 .
Brake Line Tool Kit - Pipe Cutter:VAS6056/2
Brake Line Tool Kit - Brake Line Scraper:VAS6056/3
- The threaded pins (in shaft and at sides) are set and must not be adjusted!
Brake Line Tool Kit - Grips with Plastic Jaws:VAS6056/4
Brake Line Tool Kit - Pipe Bending Tool:VAS6056/5
6 mm Offset Screwdriver
Brake Line Tool Kit - Clamp Jaws:VAS6056/6 or Brake Line Tool Kit - 1 Set of Clamp Jaws:VAS6056/7
- Brake Line Tool Kit - Flaring Jaws:VAS6056/6 for black brake lines
- Brake Line Tool Kit - Flaring Jaws:VAS6056/7 for green brake lines
  NOTE:
  The arrow on the rounded side of the flaring jaws must face toward edge of housing and the straight side of the flaring jaws must be installed toward spindle, otherwise the flared head will not be formed correctly.