Driveshaft, Removing And Installing: Notes
Special tools and workshop equipment required
- Counterhold - Multiple Use:T10172A
Perform work on driveshaft on a two-column workshop hoist if possible.
Label the position of all the parts to each other before removing them. Install in the same position otherwise the imbalance will be excessive and the bearings could get damaged causing rumbling noises.
Do not bend the driveshaft, only store and move when fully extended.
Do not allow the driveshaft to >>hang down<< during removal. Always support it.
Always remove or install the driveshaft horizontally with respect to the drive flange.
Special tools and workshop equipment required
- Counterhold - Multiple Use:T10172A
Perform work on driveshaft on a two-column workshop hoist if possible.
Label the position of all the parts to each other before removing them. Install in the same position otherwise the imbalance will be excessive and the bearings could get damaged causing rumbling noises.
Do not bend the driveshaft, only store and move when fully extended.
Do not allow the driveshaft to hang down during removal. Always support it.
Always remove or install the driveshaft horizontally with respect to the drive flange.