Calibration Device: VAS 721 001, INSTALLING AND ALIGNING: Requirement
- The camera lenses must be clean, only clean the camera lenses.
- Check the camera images on the front display. Replace the camera if the images are unclear because the camera has been damaged. Check the fastener for the camera if the image is low.
- Make sure both exterior rearview mirrors are folded out.
- The parking brake must be set.
- The steering wheel must be in the 0 position and the wheels must be straight.
- All doors and the rear lid must be closed.
- No one should be in the vehicle.
- The vehicle must not be loaded (curb weight).
- The battery charger is connected, the battery charger must not be in the view of the camera.
- Ignition switched on.
- The system is active and illustrated on the front display.
- Do not move the vehicle during the calibration process.
Requirements for the calibration equipment/calibration environment
- flat calibration surface
- Do not use any objects in the environment of the calibration field, to prevent a false recognition of lines
- Even light (no headlamps or direct illumination), prevent strong light differences
Special tools and workshop equipment required
- Calibration System:VAS 721 001
- Vehicle Diagnostic Tester
Overview of the installed Calibration System:VAS 721 001 .
CAUTION:
Reflections affect the camera and may make it impossible to perform the calibration.
- Make sure light does not reflect off the Calibration System:VAS 721 001 .
- Left Calibration Pattern
- From the Calibration System:VAS 721 001
- Front Peripheral Camera -R243-
- Calibrating. Refer to PERIPHERAL CAMERA SYSTEM, CALIBRATING .
- Right Calibration Pattern
- From the Calibration System:VAS 721 001
- Right Peripheral Camera -R245-
- Calibrating. Refer to PERIPHERAL CAMERA SYSTEM, CALIBRATING .
- Rear Peripheral Camera -R246-
- Calibrating. Refer to PERIPHERAL CAMERA SYSTEM, CALIBRATING .
- Left Peripheral Camera -R244-
- Calibrating. Refer to PERIPHERAL CAMERA SYSTEM, CALIBRATING .