All-Wheel Drive Control Module With Adjustment Motor, Removing And Installing: Removing

-- Connect the Vehicle Diagnostic Tester.

Left side

• Press the System 8126 left rear axle torque distribution J1257  .
• Select function Replace control module  follow the instructions on the tester when replacing.

Right side

• Press the System 8127 right rear axle torque distributions J1258  .
• Select function Replace control module  follow the instructions on the tester when replacing.

-- Remove the bolts -1-  . At the same time, remove the protective plate -2-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the connector -1-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolts -2-.

-- Pull the rear axle torque vectoring actuator -3- out of the final drive.