Transmission Control Module --, AQ300-8F (8 SPEED) 09S (2021/2022 MY): Footnote:

Common parameters for enabling gear ratio or lock up errors:

• Garage shifting none
• Time after garage shifting >= T_GarageFin
• Shifting none
• Time after shifting >= T_ShiftFin
• Quick turning condition FALSCH
• Wheel spin condition (only for Unusual shifting in Gear ratio) FALSCH Time after spinning change from TRUE to FALSE (only for Unusual shifting in Gear ratio) >= 10s SC2, SC3 solenoid No fault
• Linear solenoid (SL1, SL2, SL3, SL4, SL5, SL6, SLT) No fault
• CAN Bus No fault
• ECU communication No fault
• ECU message counter No fault
• ECU checksum No fault
• ECU level No fault
• Engine speed No fault
• Lever position No fault
• ROM No fault
• RAM No fault
• Gear ratio No fault
• Power supply cut for linear solenoids (SL1, SL2, SL3, SL4, SL5, SL6, SLT) Deactive Time after power supply cut for linear solenoids (SL1, SL2, SL3, SL4, SL5, SL6, SLT) >= 8s Engine stall avoidance control Deactive
• ** depend on message cycle rate