Steering Column, Removing And Installing: Installing
-- Install the steering column -1- with the opening into the guide -arrow-.
Only in This Way Is the Correct Installation Position of Steering Column to Mounting Bracket Guaranteed.
Always follow the bolt installation sequence when installing the steering column.
-- Secure the steering column with the bolt -1-.
-- Install the brake pedal crash bolster -2- and secure it with the bolt -1-.
Vehicles with a DSG Transmission and Automatic Transmission
-- Secure the steering column with the bolt -1-.
Vehicles with Manual Transmission
-- Install the clutch pedal crash bolster -2- and secure it with the bolt -1-.
Continuation for All Vehicles
-- Tighten the bolts -1 through 4- one after the other to the tightening specification.
-- Install the cable guide -1- under the steering column.
Tabs -arrow- must engage into guide on both sides.
-- Attach the ground cable to the steering column -arrow-.
-- Install the universal joint -1- on the steering pinion in direction of -arrow-.
-- Install and tighten the new bolt -arrow-.
-- Install the footwell trim -2- and tighten the nuts -1-.
Vehicles with Ignition Switch
-- Connect the connector -1-.
Vehicles with "Keyless Access" Keyless Locking and Starting System
-- Connect the connector -1-.
-- Clip the wire into the retainer on the Electronic Steering Column Lock Control Module -J764- -arrow-.
Continuation for All Vehicles
-- Install the steering column switch. Refer to Steering Column Switch Module .
-- Install the steering column trim. Refer to OVERVIEW - STEERING COLUMN TRIM PANEL .
-- Install the steering wheel. Refer to STEERING WHEEL, REMOVING AND INSTALLING .
-- Install the driver side airbag unit. Refer to AIRBAG UNIT WITH IGNITER, REMOVING AND INSTALLING .
-- Perform a basic setting on the Steering Angle Sensor -G85- using the Vehicle Diagnostic Tester.