Accelerator Pedal Module, Removing And Installing: Installing

Fig 1: Accelerator Pedal Module, Connector, Cap, Bolt, Retaining Pins & Centering Pin

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Connect the connector -2- to the accelerator pedal module -5-.

-- Push the accelerator pedal module onto the retaining pin -5-.

-- Insert the centering pin -6- into the hole on the underbody.

-- Secure the accelerator pedal module with the bolt -2-.

-- Install the cap -3-.

-- Install the steering column cover -arrows-.

Fig 2: Identifying Steering Column Cover

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- If the accelerator pedal module was replaced, adapt it to the engine control module using the Vehicle Diagnostic Tester in "Guided Functions"  .

-- If the accelerator pedal module was replaced on vehicles with an automatic transmission, then the kick-down function must be adapted using the Vehicle Diagnostic Tester in "Guided Functions"  .

Tightening Specification: