Door, Adjusting

Special tools and workshop equipment required

Wrench - Door Adjusting :3320
Door Adjusting Wrench - Joint :3320/1
Wrench - Door Adjusting - Box Wrench :3320/2
Wrench - Door Adjusting - Box Wrench :3320/3

Fig 1: Identifying Door Adjusting Wrench 3320, Joint For 3320 3320/1, Box Wrench 3320/2 And Box Wrench 3320/3
Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
Torque Wrench, 6-50Nm :VAG1331A

Fig 2: Identifying Torque Wrench
Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
Cylinder Head Bolt Socket :3410

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
Adjustment Gauge :3371

Fig 3: Gap Adjustment Gauge (3371)
Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

Adjust the doors when the vehicle is resting on its wheels.

Perform corrosion protection measures on the hinges and the bolts after assembling or adjusting.

Gap Dimensions, Adjusting

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

For correct gap dimension adjustment, screws -2, 3, 5 and 6- at the A-pillar must be loosened.

-- To loosen the bolt -3- on the driver side, loosen and lower the fuse box. Refer to RELAY AND FUSE PANEL BEHIND INSTRUMENT PANEL ON DRIVER SIDE, REMOVING AND INSTALLING .

-- To loosen the bolt -3- on the front passenger side, remove the glove compartment. Refer to GLOVE COMPARTMENT, REMOVING AND INSTALLING .

-- To loosen the bolt -6-, remove the A-pillar lower trim panel. Refer to A-PILLAR TRIM PANEL, REMOVING AND INSTALLING .

Gap dimensions. Refer to CENTER BODY

Flush Dimension Adjustment

The bolts -4- and -7- must be loosened in order to correctly adjust the flush dimension.

Use the Wrench - Door Adjusting :3320 with the respective bit for this.

NOTE:

Other measures, such as aligning the front door upward, are not effective. Later pressure will cause the front door to sag again.

Adjust the striker. Refer to STRIKER, ADJUSTING .

Tightening Specifications